First, you’ll want to make sure that the Element has an adequate amount of charge on the battery – use the included cable to charge the battery to full capacity before using it for the first time. Simply attach the smaller end of the USB cable to the Element and the other end into a USB port or charger. Once your device is charged, you’ll want to remove the top mouthpiece assembly by pressing down on the center button on top of the device. Next, remove the glass bubbler and fill with cool water by filling through the top hole – you’ll want to make sure you fill right to or below the marked line on the bubbler. You can load your concentrate into the atomizer now or wait until the heating process begins – gather a small amount of your product onto the scoop carb cap or other dab tool and place into the bottom of the atomizer. Replace the top mouthpiece assembly.
Remove the black plug from the mouthpiece and set aside or inside of the swing-out compartment on the front of the device. To start the device, press the white button on the side of the Element three times – the light ring will blink three times in white. Pressing the button once more will begin the temperature selection and heating cycle. Continue to press the button to change temperature levels – the light ring will illuminate in blue to indicate the current level and will begin to heat the device. Once the desired temperature level is reached, allow the Element to come to temperature. Once the light ring is green, your temperature is dialed in and you’re ready to produce vapor! To begin producing vapor, gently inhale on the mouthpiece while pressing down on the carb cap. The Element will continue to heat the glass atomizer for 45 seconds after the green light has come on. Continue producing vapor for as long as desired – if you want to stop the heating process, hold down the button while the Element is heating. The lights will shutoff and the Element will return to standby mode. To start the heating cycle, press the button once – the light ring will illuminate in blue, and the Element will begin to heat again. Once the light ring has turned green, you’re ready to go again!
Once the heating cycle is complete, it’s recommended to wipe out the inside of the atomizer with a cotton swab or Q-Tip to clean up any residual oil. Let the atomizer cool a little before cleaning it out to ensure you don’t handle any hot material.